ExaSound e22 Manual do Proprietário descarregar pdf (Página 19)

Using the e22 DAC

Using the Asynchronous USB Input

Before turning your amplifiers ON, always check the e22 DAC front panel to make sure

that the volume level is below -25dB.

Please follow the safety measures below strictly. It is quite common to set the volume on

your Mac to maximum. You should never do this when your e22 DAC is connected to

powerful amplifiers and speakers. Playing music or sound effects at maximum level is

dangerous for your health and may damage your audio equipment.

Please note that the e22 DAC will match the volume level of your Mac when it is turned

on. Higher volume from previous use will result in the e22 volume level rising.

• The e22 DAC can be controlled from the front panel buttons, using an IR remote control or from

the Mac screen.

• Make sure that your power amplifier is turned off.

• Make sure that all cables are connected.

• Turn on the unit using the Power button on the front panel of the remote control. The front

panel display will light up. After powering on the USB Input is selected by default.

• Lower the volume to at least -25 db. The volume on the e22 DAC can be controlled from the

Mac screen, from the device front panel, or with the remote control.

• Make sure that the desired volume level is displayed on the DAC front panel.

• Turn on your power amplifier.

Page | 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Sem comentários

ExaSound e22 Manual do Proprietário Página 19